Welcome, Guest
YaBB - Yet another Bulletin Board
  Welcome to the American Killifish Association FORUMs...  Please Join the AKA!
  HomeHelpSearchReturn to AKA Homepage  
Page Index Toggle Pages: 1
Send Topic Print
Drilling Tanks (Read 1293 times)
Kenneth P. Simolo
Junior Member

Posts: 5
Drilling Tanks
Jul 13th, 2020 at 12:29am
For anyone needing to drill a lot of tanks, I found this hole saw guide to work very well and much less of a hassle than the guides I made.


There are much cheaper ones but they have very small suction cups.

That guide was used in conjunction with a water swivel similar to the one linked below.  However, mine has a drill chuck instead of a collet and it has a small valve instead of just the nipple. 


The hole saws I use are the bonded diamond style where the diamond is dispersed through out the bonding material and is good for a 100 tanks or more (I have drilled hundreds of holes with mine).  I know Jehmco carries them among others.

Even thin glass 2 1/2 gallon tanks drilled successfully with the setup mentioned.


Back to top
IP Logged
Page Index Toggle Pages: 1
Send Topic Print